Nicolas Hanson December 16, 2017 Share December 16, 2017 Is it possible to desaturate an image not only globally, but in lift, gamma and gain? In Davinci Resolve? Link to comment Share on other sites
Mike Leisegang December 16, 2017 Share December 16, 2017 Well, have you tried it, what does it do. The other question is, what is full saturation? Your scopes should tell you. Link to comment Share on other sites
Nicolas Hanson December 16, 2017 Author Share December 16, 2017 I used the term global saturation that saturates the whole image, but I can't find controls that affect lift-only, gamma-only and gain-only. Does that exist? Link to comment Share on other sites
Orash Rahnema December 16, 2017 Share December 16, 2017 If i understood what you'r asking, then lum vs sat curve is what you'r After 1 Link to comment Share on other sites
Nicolas Hanson December 16, 2017 Author Share December 16, 2017 4 minutes ago, Orash Rahnema said: If i understood what you'r asking, then lum vs sat curve is what you'r After Ah... thanks! When I tried to figure this out I raised the R,G and B-channels on the LIFT primary, and what I saw was that this actually lowered the saturation. But when raising one of them only, lets say the Red, in did the opposite - added more Red. Can someone explain why it is behaving this way? Link to comment Share on other sites
Mike Leisegang December 16, 2017 Share December 16, 2017 Are you talking about controling just the saturation within those three specific ranges individually. The three intersect at two point. Yes, I think it is possible but I might be open to correction here. I'm sure I did something along these line during some early training. 1 Link to comment Share on other sites
Mike Leisegang December 23, 2017 Share December 23, 2017 I have recieved confirmation that it can be done. Two ways including the above.. Link to comment Share on other sites
