Canberk Erdoğan

Resolve Node Disable/Enable Crash

Recommended Posts

Hello everybody,

I encounter a problem when ı work with complicated node trees. When ı disable and enable some of the nodes resolve stops working. Do you have any ideas about that issue?

Share this post


Link to post
Share on other sites

Me too. Disable / Enable nodes can give the spinning wheel of death on MACos.

Sometimes frequently. We have talked to BMD design, but no fixes yet.

The bug is intermittent, therefore, in my case, difficult to replicate 100%.

Share this post


Link to post
Share on other sites

I encountered this problem when on the mini panel and the tab is on key palette+enable/disable. I tried contact bmd several times and at the end i was lost in oblivion again.

Share this post


Link to post
Share on other sites

I haven't seen this problem in 15.3.1 on Mac OSX 10.14.5, either with the Mini Panel or the Advanced Panels.

How many nodes? What specific hardware are you using? I typically use anywhere between 15 and 30 nodes, but there's a lot of "it depends" in there. I do run with quite a few nodes bypassed when they're not needed, but I certainly do a lot of enable/bypass actions when I'm doing a trim pass.

Share this post


Link to post
Share on other sites
3 hours ago, Marc Wielage said:

I haven't seen this problem in 15.3.1 on Mac OSX 10.14.5, either with the Mini Panel or the Advanced Panels.

How many nodes? What specific hardware are you using? I typically use anywhere between 15 and 30 nodes, but there's a lot of "it depends" in there. I do run with quite a few nodes bypassed when they're not needed, but I certainly do a lot of enable/bypass actions when I'm doing a trim pass.

Ei Marc, I think the issue is due to the usb, I changed to ethernet and the issue disapeared. Now my knobs are little bit laggy but at least there is no crash. I'm using a i9 64gb ram dual 1070, and I do work usually with around 20 fixed nodes, but I tried and this issue can be replicated with 2 nodes. I do think is a hardware problem.

Share this post


Link to post
Share on other sites

Hi Guys

Having this same problem with Micro Panel on Windows 10 and 15.3.1.

Unplugged the micro panel and I can disable on and off using the keyboard all day long.
When I plug it in it hangs after 1-4 presses depending on its mood.

I can't work out why exaactly its happening. I'll be working away with no problems and then suddenly its a problem and doesnt go away no matter how many times I close down and reopen. One trigger for the problem seems to be changing the opacity of a compound node somewhere in the project and it is only a trigger issue on certain clips. I'm pretty baffled.

Intel - i7 4770

32GB RAM

1080Ti 11GB

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.